感谢各位钓友昨日回帖，现在发一些MAXIMA渔线的一些打结方法
现在给各位路亚钓友上传一些MAXIMA所教的一些钓线打结方法以及渔线的一些保养知识，虽然是英文，但相信各位钓友能够看示意图读懂：更多产品介绍请登陆MAXIMA。中国 www.maximaline.cn
Line-To-Terminal Tackle KnotsImproved Clinch Knothttp://www.maxima-lines.com/images/clinch%20knot.gifThis is probably the most common of all fishing knots, perhaps owing to its simplicity. You can increase the strength by doubling the line when you tie this knot.
(1) Pull the line through the eye and double back, making five turns around the standing line.
(2) Holding the coils, pull the tag end through the loop closest to the eye, then back through the big loop you just created.
(3) Slide the knot tight and trim the tag end.
Palomar Knothttp://www.maxima-lines.com/images/palomar.gifOne of the strongest, most durable and easiest knots to tie, recommended for almost any application, except extremely heavy leader lines.
(1) Double about six inches of line and pass it through the eye.
(2) Tie an overhand knot.
(3) Pass the hook, lure or swivel through the loop.
(4) Tighten the knot and trim the tag end. Make sure the two lines in the eye are parallel. If they are crossed, cut the knot and re-tie. Uni-Knothttp://www.maxima-lines.com/images/uni_knot.gifA strong, versatile knot which can also be tied to form an end-loop that tightens down to a conventional knot once you hook a fish.
(1) Run six inches of line through the eye and fold it back to make two parallel lines.
(2) Bring the tag end back toward the eye and make six spiral wraps around the two parallel lines.
(3) Snug the knot; to leave a loop, hold the knot at the point where you want it while you pull on the standing line.
(4) If you don’t want a loop, slide the knot to eye. Trim the tag end.
Snelling a Hookhttp://www.maxima-lines.com/images/snell.gif“Snelling” is essentially a Uni-Knot tied around a hook shank. Where a hook has an offset eye, this knot allows for an efficient “straight pull” of the hook’s point.
(1) Thread the line through the hook eye about six inches. Form a loop and hold it against the shank of the hook.
(2) Make five or six turns through the loop and around the hook shank.
(3) Close the knot and tighten by pulling the standing line in one direction and the hook in the other. Trim the tag end.
Line-To-Line KnotsBlood Knothttp://www.maxima-lines.com/images/bloodk.gifOne of the best knots for splicing two monofilament lines of similar diameter — or for joining two dissimilar-diameter lines by doubling the lighter of the two.
(1) Overlap the two parallel lines by 12 inches total. Take five wraps on one side and pull the end back through between the two strands.
(2) Repeat on the other side, pulling the other end through the strands in the opposite direction.
(3) Pull the two tag ends slowly to gather the knot, and
(4) once gathered neatly, pull the standing line to tighten the knot. Trim the tag ends.
Surgeon's Knot http://www.maxima-lines.com/images/surgeon.gifThis easy-to-tie knot is popular for joining a heavy monofilament leader to a lighter monofilament main line.
(1) Lay six to eight inches of line and leader parallel and overlapping.
(2) Using the two lines, tie an overhand knot.
(3) Proceed to tie a second overhand knot.
(4) Pull both lines in opposing directions to gather and tighten the knot. Trim tag ends.
Nail Knothttp://www.maxima-lines.com/images/nail.gifDesigned for splicing a monofilament leader to a fly line. As the name implies, a nail is needed to tie this knot, although a toothpick or straw can be substituted.
(1) Lay eight to 10 inches of leader and fly line overlapping and parallel to each other, with a six-penny nail in-between.
(2) Using the leader line, loop up to eight coils back around the fly line, the nail and the leader. Using the nail as a guide, run the leader line back under the coils.
(3) Hold the loosely-gathered knot with one hand as you withdraw the nail with the other hand.
(4) Pull on both ends of the leader line to tighten the knot. Trim the tag ends of the leader and the fly line.
Albright Knot http://www.maxima-lines.com/images/albright.gifThis is one of the most reliable means of joining two monofilament lines that are of dissimilar diameter.
(1) Create a loop in the heavier monofilament line. Pass about 10 inches of lighter line through the loop.
(2) Take12 tight wraps back around the heavier strands and the standing portion of the lighter line.
(3) Pass the tag end of the lighter line out through the loop on the opposite side of where it entered.
(4) Hold the two heavy mono strands securely as you alternately pull on the tag end and standing part of the lighter line to begin tightening the knot.
(5) Seat the knot by pulling on the standing parts of both lines. Trim the tag ends.
Loop KnotsSurgeon’s End Loophttp://www.maxima-lines.com/images/sendloop.gifOne of the simplest and quickest ways of creating double lines for splicing to heavy leader material or for tying directly to terminal tackle.
(1) Double the end of the main line to form a loop, with the amount you double determining the size of the loop. Tie an overhand knot.
(2) With the loop still open, bring the double line through again.
(3) Pull the standing line and loop in opposite directions to gather and tighten the knot. Trim the tag end. Once this knot is tied, create a dropper by
(4) snipping loop. Then, for drift fishing,
(5) use the shorter of the two strands for a weight, the other for a hook;
(6) vice versa for vertical presentations.
Spider Hitch Though a bit more complicated than the Surgeon’s End Loop, this is also an easy way to create a loop or double line.
http://www.maxima-lines.com/images/spider.gif(1) Double the end of the main line and bring the end of the double line around to form a small loop of double line, holding it between your thumb and index finger.
http://www.maxima-lines.com/images/spider2.gif(2) Wrap the larger double line loop four to five times around thumb and small loop; then
(3) pull remainder of larger loop through the smaller loop so wraps will unwind off of thumb.
http://www.maxima-lines.com/images/spider3.gif(4) Hold the main line and tag end while you pull the double line to gather and tighten the knot. Trim the tag end.
Dropper Loophttp://www.maxima-lines.com/images/dropper.gifThis is a good knot for creating one or more loops in a leader (or main line) for attaching hooks, jigs or a sinker.
(1) Form a loop to the size you desire.
(2) Twist the loop around the main line eight times.
(3) Reach through the center of the twists and pull the loop through.
(4) Hold the loop with your teeth (be careful not to nick the line) while you pull on both ends of the main line to tighten the knot.
Double Line Leader KnotBimini TwistThe strongest loop knot of all — but also the most difficult to tie — the Bimini Twist is used to create double line for pursuing strong saltwater fish with relatively light line. These directions are for creating a double line of five feet or less. Two people may be required for anything longer. You will need to practice this knot a lot to get it right.
http://www.maxima-lines.com/images/bim.gif(1) Measure a loop slightly more than twice the footage you want for the double line. Holding the standing line and tag end together, twist the loop about 20 times.
http://www.maxima-lines.com/images/bim2.gif(2) Sit down and put your legs into the loop and apply outward pressure. At the same time, pull out on the standing line and tag ends to force the twists tightly together.
(3) Maintaining leg pressure, hold the standing line in one hand with the tension slightly off vertical. With the other hand, move the tag end to a right angle from the twists and gradually ease tension. The tag line should begin to roll over the twists.
(4) Continue outward leg pressure on the loop. Steer the tag end into a tight downward spiral over the twists.
(5) Continue to maintain leg pressure once the tag end reaches the bottom of the twists. With the hand that has been holding the standing end, place index finger in crotch of line where loop joins knot to prevent slippage of last turn. Take a half-hitch with tag end around one strand of the loop and pull it tight.
http://www.maxima-lines.com/images/bim3.gif(6) With the half-hitch holding the knot, you can release leg pressure, but keep the loop stretched out. With the remaining tag end, take a half-hitch around both strands of the loop, but do not pull tight.
(7) Take two more turns around both strands of the loop, winding inside the bend of the line formed by the loose half-hitch and toward the main knot. Put the tag end through the bend of the loose half-hitch created in step 6.
(8) Pull the tag end to gather and tighten the loops around the main knot. Trim the tag end.
TYING A GOOD FISHING KNOT:
YOUR CRITICAL CONNECTION™ TO SUCCESS Maxima makes the world’s strongest, most durable monofilament fishing line. Yet all of that strength and power is meaningless if you have a bad knot. It will break faster than you can shout “Hook up!” That’s why we call this page the Critical Connection™. Above you will find some practical knots appropriate for just about any angling situation — from finesse fly fishing to trolling for big game saltwater species. There certainly are a lot more fishing knots, but what you find are some of the most common and useful. WHY DO FISHING KNOTS FAIL?
At knot connection points, the line is twisted, criss-crossed and joined with the hard surfaces of hooks, lures, swivels and other terminal tackle. Even with a good knot, this places a great deal of stress on the line. Abrasion can be a problem. Or, under enough pressure, the line may actually cut into itself. This can reduce the effective test strength and durability of your line. For example, though you may be fishing with 10-pound test line, a bad knot may test out at only five pounds — possibly less. The idea of a good knot is to maintain close to 100 percent of the test strength of the line you’re using. The first step in this process is to choose the best knot for the application. The second step is to tie the knot properly. These instructions will help you in both regards, but here are a few other tips: KNOT TYING TIPS
Wet the knot. This is especially critical as you draw the knot tight. A little bit of water or saliva helps lubricate the line, preventing abrasion and making it easier to gather and tighten the knot. Make sure the knot is tight. A loosely gathered knot can come unraveled — or it may start to slip under pressure. Slippage can lead to rapid knot failure. Trim the knot carefully. As you trim the loose line after finishing the knot, don’t nick or scrape the actual knot or main line. Even a minor nick seriously weakens a knot. Check knots frequently. Inspect your line and knots whenever you reel in. If there’s any damage, abrasion or doubt, cut the problem off and re-tie. Learn a few knots very well. Don’t try to learn every fishing knot ever invented. There are hundreds. It’s better to be proficient with six knots than to be a “fumble-fingers” with twenty. Practice makes perfect. Spend time at home practicing your knot-tying skills. Inspect and test each knot after you finish. Your goal should be a perfectly tied knot every time. Here are a few tips for getting the most out of your Maxima monofilament fishing line. Store Line Properly
Store your line, either still on the package spool or on the reel, in a cool, dark dry place. Avoid storing line where it can be exposed to light or heat. Spool Line Tight
Spool monofilament line onto the reel as tightly as possible. This helps keep the line from “digging in” to the rest of spool when you hook a strong, hard-running fish. Keep Reel Spools Full
Keep your reels full of line. Reels that are low on line do not cast or retrieve as well as reels that are adequately filled with line. But do not overfill the reel. This can create other problems. Change Line Often
Re-spool line frequently. Change line at least every two to three trips — more often if you’ve been catching a lot of big fish or working abrasive cover. Prevent Line Twists
To prevent twisted line on your spinning reel, spool the line from the storage spool in spiral fashion, in the same direction as the spinning reel bail is turning. Wet Line For Fishing
Wet your line before fishing. Boat anglers do this by letting out 50 to 75 yards of bare line (no lure or other terminal tackle) behind a moving boat, then reeling it in tightly on the reel spool. If you’re not on a boat, make a few practice casts with a lure or weight to wet the line before you start fishing. 36_2_47 36_2_47 好贴！！ 收起来了！！ 顶上。。[装可爱] [冲锋] :36_2_5F25 :36_2_5F25 :36_2_5F25 :36_2_5F25 多谢分享！:36_2_5F25 谢谢分享哟~~~~~ :36_2_5F25 :36_2_5F25 谢谢分享 收藏了``` 不错很实用，值得收藏:36_2_5F25 :36_2_5F25 :36_2_5F25 p23b p23b 学习了，也谢谢了。
页:
[1]
2